Plug & Play Wiring Harnesses
These harnesses will allow the user to safely wire up their xenon/halogen lighting and horn systems by running power directly from the battery through a relayed harness that will be triggered by an OEM connector. This way the stock wiring system is not overloaded which can cause issues such as wires melting or even catching on fire. Using relays eliminates the need to power up your lighting system from the already insufficiently thin stock wiring. The output from your lighting system may be compromised since users may experience voltage drop by directly taking the power from the stock wiring. Using relays and our 14 gauge wiring provides the right amount of current carrying capacity to bring your system up to full performance. Do it right from the start since this is not the place to cut corners!
Relays - We use high quality Tyco relays (formerly Bosch which makes relays for many OEMs)
Relay Sockets - Many harness makers skip this step, but this step makes replacing a relay a snap, in case for whatever reason the relays do fail.
Waterproof ATO Fuse Holders - Used in case of a short. Systems use main fuses before the relay. You also have the option of adding a fuse before each ballast, although we feel this is unnecessary.
Direct plug into stock wiring - Absolutely no modifications to the car needed besides in some applications an addition of a quick disconnect which is supplied in the kit. We can either leave the ends bare for you to crimp or solder whatever you need "Flying Lead", terminate the ends with Crimped on Quick Disconnects, or you can send me the appropriate connectors for your ballasts and bi-xenon solenoids or High Beam bulbs and we will solder them on. There is no cost difference between these options.
Split Loomed - For the OEM look and to protect the wiring. All connections are soldered and heat shrunk wherever possible. Soldering gives a very strong airtight joint. We use quality Adhesive Lined heat shrink.
No Diodes Used! - We feel that using Diodes is the easy way out and we do not use them in our harness systems.
Quality 14 AWG Wiring Good for 32amps. A pair of ballasts draws 15amps or so at startup. They then draw about 6amps to run. A pair of 55W Halogen bulbs draws about 10amps.
Custom Length - These harnesses are made on a custom basis; we can make it whatever length you need so that you have enough to reach where needed and to hide the wiring out of the way, but not too much to have a huge roll of it in a corner.
Already know what you want? Checkout now!